![]() In Routing -> DHCP Server -> Pool Setting, you can configure IP address pool for each subnet. (2)DHCP Server Configuration for each subnet:Īfter configuring 元 interface for VLAN, we also need to set up DHCP Server for each subnet to assign IP for the wireless clients. IP Address and Subnet Mask specify the default gateway and network size for the subnet. IP Address Mode usually is selected as Static. So VLAN can communicate like a normal subnet on IP Layer. In Routing -> Interface -> Interface Config, add 元 interface for the VLAN configured in previous steps. Configure 元 Interface and DHCP Server for VLAN on Switch. In VLAN -> 802.1q VLAN -> VLAN Config, add the ports connecting the switch and EAP to VLAN, here we take VLAN 10 and VLAN 20 as examples.VLAN10 and VLAN20 both have member ports 1/0/10 and 1/0/12. The port in Trunk mode can transmit data packets with different VLAN tags. In VLAN -> 802.1q VLAN -> Port Config, set the ports connected to EAP as Trunk mode (Port 1/0/10 and 1/0/12 in this topology). Configure VLAN and Port Attribute on Switch Now the configuration on the gateway router is done, next we will configure the switch. ![]() So in this part, the Destination is the subnet’s network address, and Next Hop is the switch’s IP, and Interface is still LAN. In Advanced -> Routing -> Static Route, you can configure the static route items, the static route configuration helps the data packet from WAN find the next hop, the 元 switch. In gateway router’s Web UI, you can configure it in Advanced -> NAT -> Multi-Nets NAT as the figure shows below.Ĭonfigure the IP and subnet mask of each subnet, and each item works for one subnet. Since there are multiple subnets requiring NAT service, the gateway which works as a NAT device needs to support Multi-Nets NAT. Configure Multi-Nets NAT and Static Route on the Gateway Router SMB Router: Multi-net NAT Available Routers, such as TL-ER6120 SMB Switch: L2+or 元 Switches, such as T2600-28TS In this document, we will give you a simple step-by-step guide to this kind of configuration by use of TP-Link SMB router/switch and EAP/EAP Controller solution. While nowadays since the wireless devices (like smartphone and laptop) are being used more and more frequently in office, the IT department has to configure each VLAN with the different wireless network (SSID) to meet these office needs. The enterprise network is usually divided by different apartments, such as R&D, Marketing, and Product, etc. ![]() In enterprise network, we usually need to divide the network into different VLANs to isolate broadcast domain, suppressing the bad influence of broadcast traffic on network’s performance. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |